Lillington, NC HVAC & Electrical

Responded to service call for heating system that would not turn off when thermostat was set to off position. Upon inspection, found thermostat wiring connections and control board terminals. Diagnosed potential control board malfunction or thermostat communication issue preventing proper system shutdown. Documented existing wiring configuration at both thermostat and control board locations for warranty evaluation and possible recall verification.

Completed comprehensive tune-up on single HVAC system less than one year old with no reported issues. Performed full system inspection including attic ductwork examination and electrical component assessment at outdoor condensing unit. Verified proper operation of capacitor, contactor, and control board; confirmed all electrical connections secure and system operating within manufacturer specifications.

Replaced two faulty electrical receptacles in the upstairs foyer area. Tested all outlets with diagnostic equipment to verify proper wiring, grounding, and functionality upon completion.

Installed 120-volt electrical outlet near dock in backyard to provide power for decorative fountain installation by landscaping contractor. Ran circuit from electrical panel located on rear of house, which provided most direct access point to dock area. Customer specified standard outlet configuration as GFCI protection will be incorporated by landscaping contractor during fountain equipment installation.

Responded to GFCI outlet in garage tripping during rain events, preventing garage door opener operation. Performed diagnostic testing on circuit using digital measuring equipment and inspected main electrical panel for moisture intrusion and ground fault issues. Identified and resolved weather-related fault condition to restore reliable power to garage receptacle and ensure safe operation during extended absence.

Responded to service call for buzzing outlet in living room of 2004 home. Verified issue was with receptacle outlet rather than breaker switch, confirmed breaker had been checked prior to arrival. Performed comprehensive electrical testing of affected living room outlets using digital multimeter and receptacle tester, which indicated correct wiring configuration. Conducted diagnostic assessment to identify source of buzzing and evaluated all receptacles in the affected area for proper functionality and safety compliance.

Responded to no-power condition affecting all exterior outlets on 2007 home, with camper plugged into side yard outlet experiencing complete power loss. Verified main breaker panel showed no tripped breakers, then accessed crawl space to inspect electrical wiring and GFCI protection circuits serving exterior receptacles. Traced branch circuits through crawl space near HVAC equipment and determined GFCI outlet requiring reset or replacement to restore power to downstream exterior outlets and camper connection.

Installed safety switch on HVAC condensate drain line with proper P-trap configuration to prevent system operation during drain blockages. Performed complete condensate line cleanout, removing accumulated debris and sediment from drain pan and clearing drainage pathway. Installed soft start capacitor on outdoor condensing unit to reduce compressor startup amperage and extend equipment lifespan.

Conducted on-site assessment for mini split installation in detached garage. Performed detailed measurements of the space using laser distance measuring equipment to determine optimal unit placement and line set routing requirements. Documented existing conditions through photographs to support equipment sizing calculations and installation planning for estimate preparation.

Responded to service call for non-working outlets in two rooms of residential property. Upon arrival, contacted customer via phone as requested prior to entering premises. Conducted thorough inspection of affected areas, including crawlspace and attic access points to trace electrical circuits. Documented existing conditions showing aged wiring infrastructure in 1960s-era home with deteriorated insulation materials and exposed junction points in unfinished spaces. Identified compromised wiring connections in crawlspace area where moisture intrusion and structural deterioration were present. Photographed electrical components, including damaged ceiling fixtures and wiring routing through foundation penetrations. Assessed overall electrical system integrity and documented findings for customer review regarding necessary repairs to restore power to affected outlets.

Completed comprehensive heating and air maintenance on one 2018 HVAC unit including full 80-point inspection, outdoor coil cleaning, burner cleaning, gas pressure adjustment, and safety inspections. Noted significant moisture accumulation and dark residue buildup in condensate drain pan requiring attention, with EWC zone control system operating normally.

Completed comprehensive heating and air maintenance including 80-point inspection on HVAC unit. Performed outdoor coil cleaning, burner cleaning, and adjusted gas pressures to manufacturer specifications. Conducted thorough safety inspections of indoor furnace components and outdoor condenser unit, verifying proper operation of all systems.

Completed HVAC system installation including new air handler unit positioned in attic space with properly routed flexible ductwork throughout the structure. Installed new Honeywell Home programmable thermostat on interior wall, programmed and tested for proper operation at 72°F setpoint. All ductwork secured and connected to unit, system tested and verified operational with payment arrangements confirmed for future processing.

Installed a 30-amp dedicated circuit with breaker and outlet for RV camper connection at a 1969 residential property. Ran appropriate gauge wiring from the main electrical panel to the exterior outlet location, ensuring proper grounding and code compliance for the temporary camper hookup. Documented existing panel conditions and completed installation with landowner approval for seasonal use.

Completed HVAC installation including air conditioning unit with 10 KW heat strips. Installed dedicated 2A circuit breaker in electrical panel for AC unit power supply, verified all electrical connections, and ensured proper labeling of equipment and safety warnings per code requirements.

Completed comprehensive annual 32-point electrical system evaluation on 2018 residential property. Performed electrical panel maintenance including torquing all connections and verifying secure terminations. Conducted GFCI outlet testing using Klein Tools RT250 tester, confirming proper ground fault protection and correct voltage readings of 124 VAC at all protected receptacles. Tested arc fault circuit interrupter breakers to verify fire protection functionality. Performed smoke and carbon monoxide detector maintenance including battery replacement and operational testing of all units. Replaced customer-supplied light bulbs in fixtures up to 12 feet and cleaned ceiling fans up to 12 feet. All electrical systems tested and found operating within normal parameters with no safety concerns identified at time of service.

Completed comprehensive preventive maintenance on three HVAC systems, performing 80-point inspections on each unit. Cleaned outdoor coils, performed burner cleaning, adjusted gas pressures as needed, and conducted thorough safety inspections. Tested electrical components including capacitors and verified proper amperage readings using diagnostic equipment to ensure all systems operating within manufacturer specifications.

Completed sales consultation for full HVAC system replacement on 14-year-old equipment. Exterior condensing unit confirmed to have refrigerant leak and oil leak as previously diagnosed by warranty company. Interior air handler located in attic found to have exposed electrical wiring, organic matter contamination, and non-functional safety features requiring immediate attention. Documented equipment conditions with photos showing exterior unit placement, condensate drainage system, and surrounding installation area. Provided system replacement options and recommendations to address all identified safety and operational concerns.

Conducted sales consultation for complete HVAC system replacement on 29-year-old equipment from 1997. Met with tenant on-site, documented existing indoor and outdoor unit conditions with photos including system location and electrical panel configuration. Contacted property owner to review findings and discuss replacement options for both components as requested.

Completed comprehensive 32-point annual electrical system evaluation including full panel maintenance with torque verification of all connections and bus bar assemblies. Performed GFCI/shock protection testing on all applicable outlets and breakers, arc fault circuit interrupter testing for fire protection compliance, and smoke/CO detector maintenance with battery replacement and functionality verification. Observed brownish-orange staining on lower electrical panel exterior indicating possible past moisture intrusion; panel interior components and connections found dry and functioning properly with no corrosion present. All circuit breakers tested and confirmed operational, wiring secured and properly terminated, and panel labeling verified for accuracy. Replaced customer-supplied light bulbs in fixtures up to 12 feet and performed ceiling fan cleaning services as requested.

Installed NEMA 14-50 outlet for electric vehicle charging at residential property. Assessed existing electrical service panel capacity, ran new dedicated 50-amp circuit from main breaker panel, and installed appropriate wiring and outlet receptacle to accommodate EV charging requirements. Verified proper grounding, circuit protection, and code compliance upon completion.

Completed comprehensive 32-point annual electrical system evaluation including electrical panel maintenance with proper torquing and connection verification. Performed GFCI/shock protection outlet and breaker testing to confirm proper operation, along with arc fault/fire protection breaker functionality testing. Conducted smoke and CO2 detector maintenance services including battery replacement and operational testing. Replaced customer-supplied light bulbs in fixtures up to 12 feet and performed ceiling fan cleaning up to 12 feet. During inspection, documented conditions of crawlspace mechanical components and electrical panel interior, noting debris accumulation in panel compartment that should be monitored for future maintenance considerations.

Responded to no cooling call on 5-year-old Trane package unit. Upon arrival, confirmed system was non-operational with no response at thermostat. Diagnosed failed low voltage wiring connections at outdoor unit. Repaired and secured all low voltage wire terminations with new wire nuts, restoring proper electrical continuity. Tested system operation and confirmed unit now cycles properly with full cooling functionality restored.

Completed comprehensive 32-point electrical system evaluation including electrical panel maintenance with proper torquing and connection inspection of all breakers. Replaced malfunctioning exterior GFCI outlet located outside master bedroom window that was clicking and would not reset. Performed GFCI/shock protection outlet and breaker testing throughout property, arc fault/fire protection breaker testing, and smoke and CO2 detector maintenance with battery replacement and testing. Installed customer-supplied light bulbs in fixtures up to 12 feet and cleaned ceiling fans up to 12 feet. All electrical systems tested and verified to be functioning within proper parameters.

Responded to no cooling call for downstairs unit in a three-system property with three-year-old equipment. Upon inspection, discovered condensate drain line completely clogged with biological growth and sediment buildup, causing water to back up and trigger the float safety switch, which shut down the system. Cleared obstruction from drain line, removed affected section of PVC pipe showing heavy internal deposits, flushed drain system, and restored unit to normal cooling operation.