Fuquay Varina, NC HVAC & Electrical

Completed comprehensive spring preventive maintenance on residential HVAC system for new customer. Performed 80-point inspection on attic-mounted air handler unit, including burner cleaning, outdoor coil cleaning, and gas pressure adjustment to manufacturer specifications. Verified proper operation of all safety controls, refrigerant lines, condensate drainage system, and electrical connections on both heating and cooling components.

Performed comprehensive diagnostic evaluation of 15-year-old HVAC system to assess overall operational condition and investigate temperature imbalance complaints between upstairs and downstairs zones. Conducted thorough inspection of outdoor condensing unit, including examination of condenser coils showing normal dust accumulation, verification of refrigerant line connections, and assessment of electrical components including capacitor, contactor, and wiring integrity. Inspected air handler and evaluated system performance parameters to determine cause of inadequate heating and cooling in upper level while lower level maintains proper temperature. Documented equipment condition with photographic evidence of condenser coil cleanliness, electrical compartment components, and overall unit status. Provided transparent assessment of system functionality and discussed zoning options to address multi-level temperature control issues, along with recommendations for system optimization given th

Completed comprehensive preventive maintenance on 2008 HVAC system including 80-point inspection, outdoor coil cleaning, burner cleaning, and gas pressure adjustment. All safety checks passed and system operating within manufacturer specifications. Documented existing rust on corner panel and aging duct sealant with white caulking showing minor discoloration; these components remain functional but should be monitored for future maintenance planning.

Completed return visit to address HVAC system concerns. Inspected thermostat operation and verified temperature display functionality at 73 degrees. Examined air handler components including refrigerant lines, condensate drainage system, and insulation integrity throughout the unit.

Performed comprehensive electrical safety evaluation on 2009 residential property for preventative maintenance and peace of mind. Conducted systematic testing of electrical outlets throughout the home using Klein Tools RT250 GFCI outlet tester, verifying proper voltage levels (123 VAC), correct wiring configuration, and ground fault circuit interrupter functionality. All tested circuits displayed correct readings with no faults detected, confirming safe and proper electrical system operation at time of inspection.

Completed comprehensive preventive maintenance on 2022 HVAC system including full 80-point inspection, outdoor coil cleaning, burner cleaning, gas pressure verification and adjustment, and safety inspections. Discussed potential addition of garage mini-split unit to maintenance agreement with homeowner for future consideration. All equipment operating within manufacturer specifications upon completion.

Responded to no cooling callback. Upon inspection, found condensate drain pan with significant debris accumulation and standing water. Cleared blockage from drain line, flushed system, and verified proper drainage flow. System restored to normal operation with adequate airflow and cooling capacity confirmed.

Responded to a non-resetting GFCI outlet in basement affecting HVAC condensate pump operation. Upon arrival, found customer had temporarily bypassed faulty receptacle using extension cord to maintain system operation. Diagnosed failed GFCI receptacle that would not reset despite breaker remaining in normal position at main panel. Replaced defective GFCI outlet with new unit, restoring proper power to condensate pump circuit. Investigated two non-functioning basement light fixtures on same circuit and traced issue to failed connections at switch location. Repaired wiring connections and verified all fixtures operational. Tested GFCI reset functionality and confirmed proper ground fault protection. Removed temporary extension cord setup and restored condensate pump to permanent outlet connection. All circuits tested and verified operational before departure.

Completed installation of HVAC air handler unit in attic space, mounting equipment horizontally to existing framing with proper support and securing large-diameter flexible ductwork with appropriate straps. Installed dedicated 30-amp circuit breakers in electrical panel to provide proper power supply for new HVAC system.

Responded to callback on recently installed air conditioning system experiencing inconsistent airflow with cool air from only three vents while remaining vents delivered warm air. Upon inspection, discovered improper thermostat wiring configuration at the control terminal. Corrected wire connections at thermostat terminals to ensure proper system operation and verified all zones receiving appropriate conditioned air throughout the residence.