Broadway, NC HVAC & Electrical

Completed comprehensive preventative maintenance tune-up on 4-year-old HVAC system. Inspected electrical panel and circuit breakers, verified proper operation of all components, and measured supply air temperature at 66°F. All system parameters found operating within normal specifications with no deficiencies noted.

Completed installation of a new furnace/air handler unit in utility space with proper connections to existing ductwork. Installed black insulated flexible ducting throughout the space with appropriate routing through structural framing. System was properly secured with all necessary components connected and tested for operation.

Responded to service call for non-operational thermostat and no heat. Upon inspection, found issues with the Genteq blower motor assembly in the air handler unit. Examined electrical connections at the terminal block where multiple colored wires (green, blue, red, black, and brown) connect to the motor. Documented condition with photos of the blower motor assembly and wiring connections for potential recall verification. System was restored to proper operation.

Completed removal of customer's existing pack unit as requested and successfully installed new HVAC system. New outdoor unit was properly positioned on concrete pad with all electrical connections and refrigerant lines securely attached to the building. Installed and programmed new Honeywell Home digital thermostat, confirming system functionality with temperature reading at 82 degrees.

Conducted system replacement evaluation for no AC service issue. Inspected electrical panel, noting available breaker space and current circuit configuration. Examined attic HVAC unit, documenting existing equipment placement, ductwork configuration, and insulation conditions. Photos taken of both electrical panel and attic installation area for replacement planning purposes.

Inspected 2009 heat pump system after customer reported unit operating at reduced capacity. Visual examination revealed significant dirt accumulation on condenser fan and components. Electrical inspection of service panel confirmed proper connections to heat pump circuit. Recommended comprehensive cleaning and further diagnostic testing to restore optimal performance.

Completed sales consultation for 21-year-old HVAC unit, documenting exterior equipment condition and electrical panel specifications. Discussed 60-month 0% financing options with customer and provided detailed replacement recommendations based on inspection of the aging system. Photos taken of exterior unit placement and electrical service panel for accurate system sizing and installation planning.

Conducted sales consultation for replacement of 20-year-old Goodman dual system. Visual inspection revealed severely deteriorated outdoor AC unit with extensive rust, corrosion, and weathering damage. Documented condition with photos showing the aged equipment and existing electrical setup including transfer switch and meter configuration for proper replacement planning.

Conducted inspection of damaged ductwork insulation at connection points, documenting torn reflective insulation and compromised seals. Scheduled installation of manual dampers to address airflow regulation issues, with parts to be acquired prior to the scheduled completion.

Performed diagnostic inspection on 11-year-old HVAC system after customer reported weak airflow and cold air concerns. Examined attic ductwork system, including main plenum and flexible ducts, noting proper installation but identifying restricted airflow to kitchen and bathroom zones. Adjusted dampers to improve distribution balance and restore proper temperature regulation.